API Guide

hardware-address
Configures the client's hardware address for manual configurations.
Syntax
hardware-address nn:nn:nn:nn:nn:nn
Parameters nn:nn:nn:nn:nn:nn — Enter the 48-bit hardware address.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
The client hardware address is the MAC address of the client machine used for manual address binding.
Example
OS10(conf-dhcp-static)# hardware-address 00:01:e8:8c:4d:0a
Supported
Releases
10.2.0E or later
host
Assigns a host to a single IPv4 or IPv6 address pool for manual configurations.
Syntax
host A.B.C.D/A::B
Parameters A.B.C.D/A::B — Enter the host IP address in A.B.C.D or A::B format.
Default Not configured
Command Mode DHCP-POOL
Usage
Information
The host address is the IP address that a client machine uses for DHCP.
Example
OS10(conf-dhcp-Dell)# host 20.1.1.100
Supported
Releases
10.2.0E or later
ip dhcp server
Enters DHCP configuration mode.
Syntax
ip dhcp server
Parameters None
Default Not configured
Command Mode CONFIGURATION
Usage
Information
Use the ip dhcp server command to enter the DHCP mode required to enable DHCP server-assigned
dynamic addresses on an interface.
Example
OS10(config)# ip dhcp server
OS10(conf-dhcp)#
Supported
Releases
10.2.0E or later
System management 231