API Guide

● Configure an IP address in A.B.C.D/x format on the interface in INTERFACE mode. The secondary IP address is the
interface’s backup IP address.
ip address ip-address/mask [secondary]
Configure VLAN
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ip address 1.1.1.2/24
You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
User-configured default VLAN
By default, VLAN1 serves as the default VLAN for switching untagged L2 traffic on OS10 ports in Trunk or Access mode. The
default VLAN is used for untagged protocol traffic sent and received between switches, such as STPs. If you use VLAN1 for
data traffic for network-specific needs, reconfigure the VLAN ID of the default VLAN.
● Assign a new VLAN ID to the default VLAN in CONFIGURATION mode, from 1 to 4093.
default vlan-id vlan-id
In the show vlan output, an asterisk (*) indicates the default VLAN.
Reconfigure default VLAN
OS10# show vlan
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 up A
Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
OS10(config)# interface vlan 10
Sep 19 17:28:10 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:notify],
%Dell EMC (OS10) %IFM_ASTATE_UP: Interface admin state up :vlan10
OS10(conf-if-vl-10)# exit
OS10(config)# default vlan-id 10
Sep 19 17:28:15 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10)
%IFM_OSTATE_DN: Interface operational state is down :vlan1
Sep 19 17:28:16 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10)
%IFM_OSTATE_UP: Interface operational state is up :vlan10
OS10(config)# do show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
1 down
* 10 up A
Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
VLAN scale profile
When you scale the number of VLANs on a switch, use the VLAN scale profile. VLAN scale profile consumes less memory.
Enable the scale profile before you configure VLANs on the switch. The scale profile globally applies L2 mode on all VLANs you
create and disables L3 transmission. To enable L3 routing traffic on a VLAN, use the mode L3 command.
NOTE:
With VLAN scale profile configuration, Layer 3 VLANs, IGMP snooping-enabled VLANs, and FCoE VLANs require
mode L3 configuration.
1. Configure the L2 VLAN scale profile in CONFIGURATION mode.
scale-profile vlan
258
Interfaces