API Guide

Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
You can only use this command on the Management port. The no version of this command removes the
duplex mode configuration from the management port.
Example
OS10(conf-if-ma-1/1/1)# duplex auto
Supported
Releases
10.3.0E or later
enable dom
Enables or disables the DOM feature.
Syntax
dom enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables digital optical monitoring.
Example
OS10# configure terminal
OS10(config)# dom enable
OS10# configure terminal
OS10(config)# no dom enable
Supported
Releases
10.4.3.0 or later
enable dom traps
Enables DOM traps if the specified parameter crosses the defined threshold three times.
Syntax
snmp-server enable traps dom {temperature | voltage | rx-power | tx-power |
bias}
Parameters temperature | voltage | rx-power | tx-power | bias — Enter the keyword to enable
DOM traps for the specified category.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables the DOM traps.
Example
OS10# configure terminal
OS10(config)# snmp-server enable traps dom temperature
OS10# configure terminal
OS10(config)# no snmp-server enable traps dom temperature
Supported
Releases
10.4.3.0 or later
286 Interfaces