API Guide

Example
OS10(config)# interface loopback 100
OS10(conf-if-lo-100)#
Supported
Releases
10.2.0E or later
interface mgmt
Configures the Management port.
Syntax
interface mgmt node/slot/port
Parameters node/slot/port — Enter the physical port interface information for the Management interface.
Default Enabled
Command Mode CONFIGURATION
Usage
Information
You cannot delete a Management port. To assign an IP address to the Management port, use the ip
address command.
Example
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)#
Supported
Releases
10.2.0E or later
interface null
Configures a null interface on the switch.
Syntax
interface null number
Parameters number — Enter the interface number to set as null (0).
Default 0
Command Mode CONFIGURATION
Usage
Information
You cannot delete the Null interface. The only configuration command possible in a Null interface is ip
unreachables.
Example
OS10(config)# interface null 0
OS10(conf-if-nu-0)#
Supported
Releases
10.3.0E or later
interface port-channel
Creates a port-channel interface.
Syntax
interface port-channel channel-id
Parameters channel-id — Enter the port-channel ID number, from 1 to 128.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command deletes the interface.
Interfaces 289