API Guide

Parameters None
Command Mode EXEC
Usage
Information
If the Fabric Switching Engine is in Full Switch mode, you must manually configure the unit ID of an
attached Fabric Expander. For more information, see Virtual ports. Use the show unit-provision
command to display the assigned and unassigned unit IDs, and service tag provision name values. Use the
unit-provision command to configure the Fabric Expander with an unassigned unit ID and provision
name.
Example
OS10# show unit-provision
Node ID | Unit ID | Provision Name | Discovered Name | State |
--------+---------+----------------+-----------------+-------|
1 | 71 | | | |
1 | 72 | | | |
1 | 73 | | | |
1 | 74 | | | |
1 | 75 | | | |
1 | 76 | | | |
1 | 77 | | | |
1 | 78 | 403RPK2 | 403RPK2 | up |
1 | 79 | | | |
1 | 80 | | | |
1 | 81 | | | |
1 | 82 | | | |
Supported
Releases
10.4.0E(R3S) or later
show vlan
Displays the current VLAN configuration.
Syntax
show vlan [vlan-id]
Parameters vlan-id — (Optional) Enter a VLAN ID, from 1 to 4093.
Default Not configured
Command Mode EXEC
Usage
Information
None
Example
OS10# show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring
VLANs
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
1 down
Supported
Releases
10.2.0E or later
shutdown
Disables an interface.
Syntax
shutdown
Parameters None
Default Disabled
Command Mode INTERFACE
304 Interfaces