Manualshelf

API Guide

ManualsBrandsDell ManualsAccess PlatformsEMC Networking MX9116n
321322323324325326327328329330
If the IOM is not part of the SmartFabric, the system displays the following error:
Enter the Username for the Admin: admin
Password:
No Fabric found for specified nodes. Please recheck and issue this command again.
Output example when you use the module replacement command in the master IOM:
admin@MX9116N-A2:~$ sfs_node_replace.py JDB1XC2 68RRNK2
Enter the Username for the Admin: admin
Password:
% Total % Received % Xferd Average Speed Time Time Time Current
Dload Upload Total Spent Left Speed
100 142 100 89 100 53 646 384 --:--:-- --:--:-- --:--:-- 649
Node replacement work-flow is initiated, the node JDB1XC2 will reboot into Fabric mode.
After successful authentication, the system initiates the module replacement workflow and the new IOM reboots and is placed
in the SmartFabric Services mode.
Connect the new IOM
After the switch reboots to the SmartFabric Services mode, connect all the cables as originally connected to the failed IOM.
View SmartFabric Services configuration
A SmartFabric is a network fabric that consists of physical resources, such as servers and switches and logical resources—
networks, templates, and uplinks. SmartFabric Services is an OS10 feature enabled on PowerEdge MX Ethernet I/O modules.
When you create a SmartFabric using the OpenManage Enterprise - Modular (OME-Modular) user interface, the switches
assigned to the fabric are automatically placed in SmartFabric mode. In SmartFabric mode, PowerEdge MX switches operate as
Layer 2 I/O aggregation devices with complete interoperability with all major network equipment vendors.
Use the OME-Modular interface to configure PowerEdge MX networking in SmartFabric mode. For more information, see:
● Dell EMC OpenManage Enterprise - Modular User's Guide, Ethernet IO Modules chapter
● Dell EMC PowerEdge MX SmartFabric Services Configuration and Troubleshooting Guide
You can enter SmartFabric Services show commands from the OS10 CLI to view SmartFabric configuration information. For
more information, see SmartFabric commands.
PowerEdge MX Ethernet I/O modules
325