API Guide

Active SW Version: 10.5.0.0

Active SW Build Version: 10.5.0.270

Active Kernel Version: Linux 4.9.168

Active Build Date/Time: 2019-07-29T23:35:01Z

Standby Partition: A

Standby SW Version: 10.5.0EX

Standby SW Build Version: 10.5.0EX.252

Standby Build Date/Time: 2019-07-27T17:31:55Z

Next-Boot: active[B]

9. Reload the new software image in the standby partition in EXEC mode.

OS10# reload

10. Use the show version command in EXEC mode to verify that the downloaded OS10 image is installed as the current

running version. The running OS10 image is in the active partition.

OS10# show version

Dell EMC Networking OS10 Enterprise

OS Version: 10.5.0.0

Build Version: 10.5.0.270

Build Time: 2019-07-29T23:35:01+0000

System Type: S4148F-ON

Architecture: x86_64

Up Time: 1 day 00:54:13

NOTE: When VLTi link is down, there should not be any configuration done in the VLT nodes. Doing so will result in

mismatch of VLT configurations between the two nodes

Install OS10 upgrade

After you download and unpack a new OS10 binary image as described in Download OS10 image for upgrade, follow these steps:

NOTE:

During the OS10 image upgrade process in a VLT setup, when the VLT peers are running different software

versions, make no configuration changes on a VLT peer. Ensure that both nodes are upgraded to the same version before

you make any configuration change.

NOTE: On an MX-Series I/O module, install OS10 upgrades in downloaded DUP files by following the instructions in the Dell

EMC SmartFabric OS10 Release Notes—Release 10.5.0.

NOTE: While performing an upgrade from 10.4.0E.R4S to 10.5.0.4 and later in GUI mode, all the IOMs may get upgraded

with a time-out notification to the OME-M or an IOM (DNV Master) may not get upgraded. Check the IOMs to ascertain

whether the upgrade was successful or not. If the IOMs did not get upgraded, re-initiate the upgrade for the impacted

nodes.

1. (Optional) Back up the current running configuration to the startup configuration in EXEC mode.

OS10# copy running-configuration startup-configuration

2. Back up the startup configuration (startup.xml) in EXEC mode.

copy config://startup.xml ftp://userid:passwd@hostip/backup_filepath/10.5.0.4-

startup.xml

3. Download the new OS10 binary image, also called the standby image, from a local server using the image download

server-filepath/filename command in EXEC mode; for example:

OS10# image download sftp://admin:passwd@10.1.1.1/home/admin/images/OS10EE.bin

4. (Optional) View the current software download status in EXEC mode.

OS10# show image status

Getting Started with Dell EMC SmartFabric OS10