API Guide

Po 10(Eth 1/1/9) 20:01:d4:ae:52:1a:ee:54 1001 Fc 1/1/25 10 FLOGI
LOGGED_IN
Supported
Releases
10.4.0E(R1) or later
F_Port and NPG commands
The following commands are supported on both F_Port and NPG modes:
clear fc statistics
Clears FC statistics for specified vfabric or fibre channel interface.
Syntax
clear fc statistics [vfabric vfabric-ID | interface fibrechannel]
Parameters
● vfabric-ID — Enter the vfabric ID.
● fibrechannel — Enter the fibre channel interface name.
Default Not configured
Command Mode EXEC
Usage
Information
None
Example
OS10# clear fc statistics vfabric 100
OS10# clear fc statistics interface fibrechannel1/1/25
Supported
Releases
10.4.1.0 or later
fcoe
Adds FCoE parameters to the vfabric.
Syntax
fcoe {fcmap fc-map | fcf-priority fcf-priority-value | fka-adv-period adv-
period | vlan-priority vlan-priority-value | keep-alive}
Parameters
● fc-map — Enter the FC map ID, from 0xefc00 to 0xefcff.
● fcf-priority-value — Enter the FCF priority value, from 1 to 255.
● adv-period — Enter the FCF keepalive advertisement period, from 8 to 90 seconds.
● vlan-priority-value — Enter the VLAN priority value, from 0 to 7.
Defaults
● fcmap—0x0EFC00
● fcf-priority—128
● fka-adv-period—8
● vlan-priority—3
● keep-alive—True
Command Mode Vfabric CONFIGURATION
Usage
Information
The no version of this command disables the FCoE parameters.
Example
OS10(config)# vfabric 10
OS10(conf-vfabric-10)# name 10
OS10(conf-vfabric-10)# fcoe fcmap 0x0efc01
OS10(conf-vfabric-10)# fcoe fcf-priority 128
380 Fibre Channel