API Guide

Example
OS10(config)# vfabric 100
Supported
Releases
10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an Ethernet or FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes the vfabric from the interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# vfabric 200
Supported
Releases
10.3.1E or later
vlan
Associates an existing VLAN ID to the vfabric to carry traffic.
Syntax
vlan vlan-ID
Parameters vlan-ID — Enter an existing VLAN ID.
Defaults Not configured
Command Mode Vfabric CONFIGURATION
Usage
Information
Create the VLAN ID before associating it to the vfabric. Do not use spanned VLAN as vfabric VLAN. The
no version of this command removes the VLAN ID from the vfabric.
Example
OS10(config)# interface vlan 1023
OS10(conf-if-vl-1023)# exit
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# vlan 1023
Supported
Releases
10.3.1E or later
FIP-snooping commands
The following commands are supported on FIP-snooping mode:
Fibre Channel
389