API Guide

Default 60 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout quiet-period 120
Supported
Releases
10.2.0E or later
dot1x timeout re-authperiod
Sets the number of seconds between re-authentication attempts.
Syntax
dot1x timeout re-authperiod seconds
Parameters re-authperiod seconds — Enter the number of seconds for the 802.1X re-authentication timeout,
from 1 to 65535.
Default 3600 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout re-authperiod 7200
Supported
Releases
10.2.0E or later
dot1x timeout server-timeout
Sets the number of seconds that the device waits before retransmitting a packet to the authentication server.
Syntax
dot1x timeout server-timeout seconds
Parameters server-timeout seconds — Enter the number of seconds for the 802.1X server timeout, from 1 to
65535.
Default 30 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x server-timeout 60
Supported
Releases
10.2.0E or later
dot1x timeout supp-timeout
Sets the number of seconds that the device waits for the supplicant to respond to an EAP request frame before the device
retransmits the frame.
Syntax
dot1x timeout supp-timeout seconds
Parameters supp-timeout seconds — Enter the number of seconds for the 802.1X supplicant timeout, from 1 to
65535.
408 Layer 2