API Guide

Default Not configured
Command Mode EXEC
Usage
Information
Neighbor information clears on all interfaces.
Example
OS10# clear lldp table
Supported
Releases
10.2.0E or later
lldp enable
Enables or disables LLDP globally.
Syntax
lldp enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage
Information
This command enables LLDP globally for all Ethernet PHY interfaces, except on those interfaces where
you manually disable LLDP. The no version of this command disables LLDP globally irrespective of
whether you manually disable LLDP on an interface.
Example
OS10(config)# lldp enable
Supported
Releases
10.3.1E or later
lldp holdtime-multiplier
Configures the multiplier value for the hold time.
Syntax
lldp holdtime-multiplier integer
Parameters integer — Enter the holdtime-multiplier value, from 2 to 10.
Default 4
Command Mode CONFIGURATION
Usage
Information
Hold time is the amount of time in seconds that a receiving system waits to hold the information before
discarding it. Formula: Hold Time = (Updated Frequency Interval) x (Hold Time Multiplier). The no version
of this command resets the value to the default.
Example
OS10(config)# lldp holdtime-multiplier 2
Supported
Releases
10.2.0E or later
lldp med fast-start-repeat-count
Configures the number of packets that are sent during the activation of the fast start mechanism.
Syntax
lldp-med fast-start-repeat-count number
Parameters number — Enter the number of packets sent during the activation of the fast start mechanism, from 1 to
10.
Default 3
450 Layer 2