API Guide

-* *-
-* Copyright (c) 1999-2018 by Dell Inc. All Rights Reserved. *-
-* *-
-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-
This product is protected by U.S. and international copyright and
intellectual property laws. Dell EMC and the Dell EMC logo are
trademarks of Dell Inc. in the United States and/or other
jurisdictions. All other marks and names mentioned herein may be
trademarks of their respective companies.
OS10# configure terminal
% Error: ZTD is in progress(configuration is locked).
OS10# ztd cancel
OS10# configure terminal
OS10(config)# username admin password alpha404! role sysadmin
OS10(config)# exit
OS10# write memory
Install OS10 license
If OS10 is factory-loaded on your switch, you do not need to install an OS10 license as it is pre-loaded with a perpetual license. If
you download OS10 on a trial basis, OS10 comes with a 120-day trial license. ONIE installation on a factory-loaded Dell EMC
switch wipes out the license partition. Hence, the switch on reload comes up with a default 120 day trial license.To continue
with uninterrupted use, purchase and install a perpetual license to avoid the OS10 device rebooting every 72 hours after 120
days.
After you install OS10 and log in, install the perpetual license to run OS10 Enterprise Edition beyond the trial period. The OS10
license is installed in the /mnt/license directory.
1. Download the License.zip file from DDL as described in Download OS10 image.
2. Open the zip file and locate the license file in the Dell folder. Copy the license file to a local or remote workstation.
3. Install the license file from the workstation in EXEC mode.
license install {ftp: | http: | localfs: | scp: | sftp: | tftp: | usb:} filepath/
filename
● ftp://userid:passwd@hostip/filepath — Copy from a remote FTP server.
● http://hostip/filepath — Copy from a remote HTTP server.
● http://hostip — Send a request to a remote HTTP server.
● localfs://filepath — Install from a local file directory.
● scp://userid:passwd@hostip/filepath — Copy from a remote SCP server.
● sftp://userid:passwd@hostip/filepath — Copy from a remote SFTP server.
● tftp://hostip/filepath — Copy from a remote TFTP server.
● usb://filepath — Install from a file directory on a storage device connected to the USB storage port on the switch.
● filepath/filename — Enter the directory path where the license file is stored.
NOTE:
When installing a license through a VRF instance, OS10 supports only some file transfer methods. Refer to the
following table for the file transfer methods supported in the default, management, and non-default VRF instances.
Table 7. Install license using VRF
File transfer method Default VRF Management VRF¹ Non-default VRF
FTP Yes Yes No
HTTP Yes Yes No
localfs Yes Yes Yes
SCP Yes Yes No
SFTP Yes Yes No
TFTP Yes Yes No
USB Yes Yes Yes
48 Getting Started with Dell EMC SmartFabric OS10