Manualshelf

API Guide

ManualsBrandsDell ManualsAccess PlatformsEMC Networking MX9116n
41424344454647484950
Hardware Version : X01
Platform Name : x86_64-dell_s4100_c2338-r0
PPID : TW09H9MN282987130026
Service Tag : 9531XC2
Product Base :
Product Serial Number:
Product Part Number :
License Details
----------------
Software : OS10-Enterprise
Version : 10.5.0.0
License Type : PERPETUAL
License Duration: Unlimited
License Status : Active
License location: /mnt/license/9531XC2.lic
---------------------------------------------------------
Troubleshoot license installation failure
An error message displays if the installation fails.
License installation failed
1. Verify the installation path to the local or remote license location.
2. Check the log on the remote server to find out why the FTP or TFTP file transfer failed.
3. Ping the remote server from the switch — use the ping and traceroute commands to test network connectivity. Check the
following if the ping fails:
● If the remote server is reachable through the management route, check if the management route is configured correctly.
● If the remote server is reachable through a front-panel port, check if the static or dynamic route is present.
● If the ping is successful and the FTP or TFTP log on to a remote server does not register a response, check if there is a
firewall in the transfer path that is blocking the transfer protocol.
4. Install the server with the license file on the same subnet as the switch.
5. Check if the server is up and running.
Switch deployment options
After you log in to OS10, configure the switch:
● Manually by using the command-line interface.
● Automatically using zero-touch deployment (ZTD).
● Automatically using customized scripts with Ansible.
Manual CLI configuration
Use the OS10 command-line interface to enter commands to monitor and configure an OS10 switch. Set up your switch by
performing basic and advanced CLI tasks — CLI basics and Advanced CLI tasks. Then proceed with other configuration settings
according to how you deploy the switch in your network. For detailed configuration and CLI information, refer to the appropriate
chapter.
ZTD-automated switch deployment
Automate OS10 switch deployment using zero-touch deployment, including:
● Upgrade an existing OS10 image.
● Execute a CLI batch file to configure the switch.
● Execute a post-ZTD script to perform additional functions.
See Zero-touch deployment.
50
Getting Started with Dell EMC SmartFabric OS10