API Guide

ipv6 route-import
Imports an IPv6 route into a VRF instance from another VRF instance.
Syntax
[no] ipv6 route-import route-target
Parameters
● route-target—Enter the route-target of the VRF instance.
Default Not configured
Command Mode VRF CONFIG
Usage
Information
You can import IPv6 routes corresponding only to a nondefault or a default VRF instance. You cannot
import IPv6 routes that belong to a management VRF instance into another VRF instance.
Use the no form of this command to remove the imported routes.
Example
OS10(conf-vrf)# ipv6 route-import 1:1 ==> No route-map attached
Supported
Releases
10.4.3.0 or later
ipv6 route-export
Exports an IPv6 route from a VRF instance to another VRF instance.
Syntax
[no] ipv6 route-export route-target [route-map route-map-name]
Parameters
● route-target—Enter the route-target of the VRF instance.
● route-map route-map-name—(Optional) Enter the route-map name to specify the route-map.
Default Not configured
Command Mode VRF CONFIG
Usage
Information
You can export IPv6 routes corresponding only to a nondefault or a default VRF instance. You cannot
export IPv6 routes that belong to a management VRF instance into another VRF instance.
Use the no form of this command to undo the configuration.
Example
OS10(conf-vrf)# ipv6 route-export 1:1 ==> No route-map attached
OS10(conf-vrf)# ipv6 route-export 1:1 route-map abc ==> Route-map abc
attached to filter export routes
Supported
Releases
10.4.3.0 or later
ip scp vrf
Configures an SCP connection for the management or non-default VRF instance.
Syntax
ip scp vrf {management | vrf vrf-name}
Parameters
● management — Enter the keyword to configure an SCP connection for the management VRF
instance.
● vrf vrf-name — Enter the keyword then the name of the VRF to configure an SCP connection for
that VRF instance.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the management VRF instance configuration from the SCP
client.
Layer 3 549