API Guide

Table 19. Command Description
Command Description
:de14:2204:fff
:fe21:7fc9
ONLINE
BACKUP
MX9116n
SKYMX10
B1
MXWV011
fde1:53ba:e9a0
:de14:2204:fff
:fe21:9f49
ONLINE
BACKUP
MX9116n
SKYMX02
A1
MX9116N-A2#
xii. After completing the above step, upgrade the
next Networking I/O Module.
xiii. After all Fabric Switching Engines are updated, all
solution components (compute, chassis, and
fabric switching engine) in this entire process will
be updated. Power cycle the MX7000 chassis
after updating all applicable solution components.
Remote access
After you install or upgrade OS10 and log in, you can set up remote access to the OS10 command-line interface and the Linux
shell. Connect to the switch using the serial port. Serial port settings are 115200 baud, 8 data bits, and no parity.
Configure remote access
1. Configure the Management IP address.
2. Configure Management route.
3. Configure user name and password.
Configure Management IP address
To remotely access OS10, assign an IP address to the management port. Use the management interface for out-of-band (OOB)
switch management.
1. Configure the management interface from CONFIGURATION mode.
interface mgmt 1/1/1
2. By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.
no ip address dhcp
3. Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode.
ip address A.B.C.D/mask
ipv6 address A:B/prefix-length
58
Getting Started with Dell EMC SmartFabric OS10