API Guide

○ ethernet — Physical interface, from 1 to 48.
○ port-channel — Port-channel interface, from 1 to 128.
○ vlan — VLAN interface, from 1 to 4093.
● vrf vrf-name — (Optional) Enter the keyword vrf followed by the name of the VRF to display
the configured OSPFv3 enabled interfaces in that VRF.
Default Not configured
Command Mode EXEC
Example
OS10# show ipv6 ospf interface
ethernet1/1/1 is up, line protocol is up
Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
Network Type broadcast, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
BFD enabled(Interface level) Interval 300 Min_rx 300 Multiplier 3 Role
Active
Designated Router on this network is 2.2.2.2
Backup Designated router on this network is 10.0.0.2 (local)
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported
Releases
10.3.0E or later
show ipv6 ospf neighbor
Displays a list of OSPFv3 neighbors connected to the local router.
Syntax
show ipv6 ospf [vrf vrf-name] neighbor
Parameters
● vrf vrf-name — Enter the keyword vrf followed by the name of the VRF to display a list of
OSPFv3 neighbors in that VRF.
Default Not configured
Command Mode EXEC
Usage
Information
● Neighbor ID—Displays the neighbor router ID.
● Pri—Displays the priority assigned neighbor.
● State—Displays the OSPF state of the neighbor.
● Dead Time—Displays the expected time until the system declares the neighbor dead.
● Interface ID—Displays the neighbor interface ID
● Interface—Displays the interface type, node/slot/port or number information.
Example
OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor
Neighbor ID Pri State Dead Time Interface ID Interface
-------------------------------------------------------------------
2.2.2.2 1 Full/DR 00:00:30 5 ethernet1/1/1
Supported
Releases
10.3.0E or later
show ipv6 ospf statistics
Displays OSPFv3 traffic statistics.
Syntax
show ipv6 ospf [instance-number] statistics [interface interface]
Parameters
● instance-number — (Optional) Enter an OSPFv3 instance number, from 1 to 65535.
742 Layer 3