API Guide

Example
OS10# configure terminal
OS10# interface vlan11
OS10(conf-if-vl-11)# ip igmp last-member-query-interval 200
Supported
Releases
10.4.3.0 or later
ip igmp query-interval
Changes the frequency of IGMP general queries sent by the querier.
Syntax
ip igmp query-interval seconds
Parameters seconds—Enter the amount of time in seconds to configure the time interval for IGMP general queries.
The range is from 1 to 18000.
Default 60 seconds
Command Mode INTERFACE
Usage
Information
None
Example
OS10# configure terminal
OS10# interface vlan12
OS10(conf-if-vl-12)# ip igmp query-interval 60
Supported
Releases
10.4.3.0 or later
ip igmp query-max-resp-time
Configures the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
Parameters seconds—Enter the amount of time in seconds, from 1 to 25.
Default 10 seconds
Command Mode INTERFACE
Usage
Information
The IGMP query maximum response time value must be less than the IGMP query interval value. The no
form of the command configures the default value.
Example
OS10# configure terminal
OS10# interface vlan14
OS10(conf-if-vl-14)# ip igmp query-max-resp-time 20
Supported
Releases
10.4.3.0 or later
ip igmp snooping enable
Enables IGMP snooping globally.
Syntax
ip igmp snooping enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
786 Multicast