API Guide

Parameters
● vrf vrf-name—Enter the keyword vrf, then the name of the VRF
● loopback-interface-number—Enter a value from 0 to 16383
● vlan-number—Enter a value from 1 to 4093
● port-channel-number—Enter a value from 1 to 128
● length—Enter a value from 0 to 32
● priority-value—Enter a value from 0 to 255
Default
● Hash mask length is 30.
● Priority is 64.
Command Mode CONFIGURATION
Usage
Information
The system advertises the IP address of the specified interface as the BSR IP address in BSR messages.
The no form of the command removes the router from being the candidate BSR. Do not specify the
parameters in the no form of the command.
Example
OS10# configure terminal
OS10(config)# ip pim vrf red bsr-candidate loopback 10 hash-mask-len 31
priority 11
Supported
Releases
10.5.0 or later
ip pim bsr-candidate-timers
Configures the time interval between candidate BSR advertisements.
Syntax
ip pim [vrf vrf-name] bsr-candidate-timers {ethernet node/slot/
port[:subport] | loopback loopback-interface-number | vlan vlan-number |
port-channel port-channel-number} advt-interval interval-value
Parameters
● vrf vrf-name—Enter the keyword vrf, then the name of the VRF
● loopback-interface-number—Enter a value from 0 to 16383
● vlan-number—Enter a value from 1 to 4093
● port-channel-number—Enter a value from 1 to 128
● interval-value—Enter a value from 1 to 2147483
Default
● Advertisement interval default is 60 s.
Command Mode CONFIGURATION
Usage
Information
Use this command to adjust the time interval between periodic BSR advertisements. The no form of the
command resets the candidate BSR advertisement interval to the default value. Do not specify the
parameters in the no form of the command.
Example
OS10(config)# ip pim vrf red bsr-candidate-timers loopback 10 advt-
interval 40
Supported
Releases
10.5.0 or later
ip pim bsr-timeout
Configures the BSR timeout value.
Syntax
ip pim [vrf vrf-name] bsr-timeout value
no ip pim [vrf vrf-name] bsr-timeout
Multicast 811