API Guide

Parameters
● vrf vrf-name—Enter the keyword vrf, then the name of the VRF
● value—Enter a value from 0 to 2147483
Default 130 s
Command Mode CONFIGURATION
Usage
Information
The no form of the command resets the BSR timeout to its default value.
Example
OS10# configure terminal
OS10(config)# ip pim vrf red bsr-timeout 140
Supported
Releases
10.5.0 or later
ip pim dr-priority
Changes the designated router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
Parameters priority-value—Enter a number from 0 to 4294967295.
Default 1
Command Mode INTERFACE CONFIGURATION
Usage
Information
The router with the highest value assigned to an interface becomes the DR. If two interfaces have the
same DR priority value, the interface with the highest IP address becomes the DR.
The no form of this command removes the DR priority value assigned to an interface.
Example
OS10# configure terminal
OS10(config)# interface vlan 1
OS10(conf-if-vl-1)# ip pim dr-priority 200
Supported
Releases
10.4.3.0 or later
ip pim query-interval
Changes the frequency of PIM router query messages.
Syntax
ip pim query-interval seconds
Parameters seconds—Enter the amount of time, in seconds, the router waits before sending a PIM hello packet out
of each PIM-enabled interface, from 2 to 18000.
Default 30 seconds
Command Mode INTERFACE CONFIGURATION
Usage
Information
The no form of this command returns the frequency of PIM router query messages to the default value.
Example
OS10# configure terminal
OS10(config)# interface vlan 1
OS10(conf-if-vl-1)# ip pim query-interval 20
Supported
Releases
10.4.3.0 or later
812 Multicast