Users Guide

Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
• host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
• capture — (Optional) Capture packets the filter processes.
• count — (Optional) Count packets the filter processes.
• byte — (Optional) Count bytes the filter processes.
• dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV6-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the filter, or use the no seq sequence-number command if you know
the filter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 deny icmp any any capture session 1 log
Supported
Releases
10.2.0E or later
seq deny ip
Assigns a sequence number to deny IPv4 addresses while creating the filter.
Syntax
seq sequence-number deny ip [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count | dscp value |
fragment | log]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• A.B.C.D — Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
• capture — (Optional) Capture packets the filter processes.
• count — (Optional) Count packets the filter processes.
• byte — (Optional) Count bytes the filter processes.
• dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV4-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the filter, or use the no seq sequence-number command if you know
the filter’s sequence number.
Example
OS10(config)# ip access-list egress
OS10(config-ipv4-acl)# seq 10 deny ip any any capture session 1 log
Access Control Lists 1059