Users Guide

Command Mode IPV6-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the filter, or use the no seq sequence-number command if you know
the filter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1 log
Supported
Releases
10.2.0E or later
seq permit (MAC)
Assigns a sequence number to permit MAC addresses while creating a filter.
Syntax
seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos
| count [byte] | vlan]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing,
from 1 to 16777214.
• nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets were sent.
• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of 00:00:00:00:00:00 applies.
•
any — (Optional) Set all routes to be subject to the filter:
• protocol-number — (Optional) Enter the protocol number identified in the MAC header, from 600 to
ffff.
• capture — (Optional) Enter the capture packets the filter processes.
• cos — (Optional) Enter the CoS value, from 0 to 7.
• count — (Optional) Enter the count packets the filter processes.
• byte — (Optional) Enter the count bytes the filter processes.
• vlan — (Optional) Enter the VLAN number, from 1 to 4093.
Default Not configured
Command Mode MAC-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the filter, or use the no seq sequence-number command if you know
the filter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any
cos 7
OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any
vlan 2
Supported
Releases
10.2.0E or later
seq permit icmp
Assigns a sequence number to allow ICMP messages while creating the filter
Syntax
seq sequence-number permit icmp [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count | dscp value |
fragment | log]
Access Control Lists 1065