Users Guide

• precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7.
• ip-any — Enter the IPv4 or IPv6 match criteria.
• dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
• ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
• precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7.
• ipv6 — Enter the IPv6 match criteria.
• access-group name name — (Optional) Enter the IPv6 access-group name.
• dscp dscp-value — (Optional) Configure a DSCP value for L3 DSCP match criteria, from 0 to 63.
• ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
• mac access-group name name — Enter an access-group name for the MAC access-list match criteria.
A maximum of 140 characters.
• dscp dscp-value — Enter a DSCP value for marking the DSCP packets, from 0 to 63.
• not — Enter the IP or CoS to negate the match criteria.
• vlan vlan-id — Enter a VLAN number for VLAN match criteria, from 1 to 4093.
Default Not configured
Command Mode CLASS-MAP
Usage Information In a match-any class, you can enter multiple match criteria. In a match-all class, if the match case is
access-group, no other match criteria is allowed. If you attach the access-list to class-map type
control—plane or qos, the access-list (IPv4, IPv6) ignores the permit and deny keywords.
Example 1
OS10(conf-cmap-qos)# match ip access-group name ag1
OS10(config-cmap-qos)# match ipv6 access-group name ACLv6
Supported
Releases
10.2.0E or later
match cos
Matches a cost of service (CoS) value to L2 dot1p packets.
Syntax
match [not] cos cos-value
Parameters
• cos-value — Enter a CoS value, from 0 to 7.
• not — Enter not to cancel the match criteria.
Default Not configured
Command Modes CLASS-MAP
Usage Information You cannot have two match statements with the same filter-type. If you enter two match statements with the
same filter-type, the second statement overwrites the first statement.
Example
OS10(conf-cmap-qos)# match cos 3
Supported
Releases
10.2.0E or later
match dscp
Configures a DSCP value as a match criteria for a class-map.
Syntax
match [not] {ip | ipv6 | ip-any } dscp [dscp-value] [ecn ecn-value]
Parameters
• not — (Optional) Enter to cancel a previously applied match criteria.
• ip — Enter to use IPv4 as the match protocol.
• ipv6 — Enter to use IPv6 as the match protocol.
Quality of service 1133