Users Guide

Command Mode Alias CONFIGURATION
Usage Information
Supported on the MX9116n switch in Full Switch mode starting in release 10.4.0E(R3S). Also supported in
SmartFabric mode starting in release 10.5.0.1
The no version of this command removes the member from the FC alias.
Example
OS10(config)# fc alias test
OS10(config-fc-alias-test)# member wwn 21:00:00:24:ff:7b:f5:c9
OS10(config-fc-alias-test)# member wwn 20:25:78:2b:cb:6f:65:57
Supported
Releases
10.3.1E or later
member (zone)
Adds members to existing zones. Identify a member by an FC alias, a world wide name (WWN), or an FC ID.
Syntax
member {alias-name alias-name | wwn wwn-ID | fc-id fc-id}
Parameters
• alias-name — Enter the FC alias name.
• wwn-ID — Enter the WWN name.
• fc-id — Enter the FC ID name.
Defaults Not configured
Command Mode Zone CONFIGURATION
Usage Information
Supported on the MX9116n switch in Full Switch mode starting in release 10.4.0E(R3S). Also supported in
SmartFabric mode starting in release 10.5.0.1
The no version of this command removes the member from the zone.
Example
OS10(config)# fc zone hba1
OS10(config-fc-zone-hba1)# member wwn 10:00:00:90:fa:b8:22:19
OS10(config-fc-zone-hba1)# member wwn 21:00:00:24:ff:7b:f5:c8
Supported
Releases
10.3.1E or later
member (zoneset)
Adds zones to an existing zoneset.
Syntax
member zone-name
Parameters zone-name — Enter an existing zone name.
Defaults Not configured
Command Mode Zoneset CONFIGURATION
Usage Information
Supported on the MX9116n switch in Full Switch mode starting in release 10.4.0E(R3S). Also supported in
SmartFabric mode starting in release 10.5.0.1
The no version of this command removes the zone from the zoneset.
Example
OS10(config)# fc zoneset set
OS10(conf-fc-zoneset-set)# member hba1
Supported
Releases
10.3.1E or later
336 Fibre Channel