Users Guide

• number — Enter a network policy index number, from 1 to 32.
Default Not configured
Command Mode INTERFACE
Usage Information Attach only one network policy for per interface.
Example
OS10(conf-if-eth1/1/5)# lldp med network-policy add 1
Supported
Release
10.2.0E or later
lldp med tlv-select
Configures the LLDP-MED TLV type to transmit or receive.
Syntax
lldp med tlv-select {network—policy | inventory}
Parameters
• network-policy — Enable or disable the port description TLV.
• inventory — Enable or disable the system TLV.
Default Enabled
Command Mode INTERFACE
Usage Information None
Example
OS10(conf-if-eth1/1/3)# lldp med tlv-select network-policy
Supported
Releases
10.2.0E or later
lldp port-description-tlv advertise
Specifies whether to advertise the interface description or the port id in the port description TLV.
Syntax
lldp port-description-tlv advertise [description | port-id]
Parameters
• description — Advertise interface description.
• port-id — Advertise port id.
Default Interface description is advertised.
Command Mode INTERFACE
Usage Information Determines whether to advertise the interface description or the port ID in the port description TLV.
Example
OS10(conf-if-eth1/1/1)# lldp port-description-tlv advertise description
OS10(conf-if-eth1/1/1)# lldp port-description-tlv advertise port-id
Supported
Releases
10.4.3.0 or later
lldp receive
Enables or disables the LLDP packet reception on a specific interface.
Syntax
lldp receive
Parameters None
Default Not configured
Command Mode INTERFACE
Layer 2 405