Users Guide

Supported
Releases
10.2.0E or later
track interface
Monitors an interface and lowers the priority value of the VRRP group on that interface, if disabled.
Syntax
interface {ethernet node/slot/port[:subport]} [line-protocol]
Parameters
• ethernet node/slot/port[:subport] — (Optional) Enter the keyword and the interface information
to track.
• line-protocol — (Optional) Tracks the interface line-protocol operational status.
Default Disabled
Command Mode EXEC
Usage Information Assign an object tracking unique ID number before tracking the interface. Use the line-protocol parameter
to track for interface operational status information. The no version of this command resets the value to the
default.
Example
OS10(config)# track 10
OS10(conf-track-10)# interface ethernet 1/1/5 line-protocol
Supported
Releases
10.2.0E or later
virtual-address
Configures up to 10 virtual router IP addresses in the VRRP group. Set at least one virtual IP address for the VRRP group to start sending
VRRP packets.
Syntax
virtual-address ip-address1 [ip-address2...ip-address10]
Parameters
• ip-address1 — Enter the IP address of a virtual router in A.B.C.D format. The IP address must be on the
same subnet as the interface’s primary IP address.
• ip-address2...ip-address10 — (Optional) Enter up to nine additional IP addresses of virtual routers,
separated by a space. The IP addresses must be on the same subnet as the interface’s primary IP address.
Default Enabled
Command Mode INTERFACE-VRRP
Usage Information The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When
you delete the virtual address, the VRRP group stops sending VRRP packets. You can ping the virtual addresses
configured in all VRRP groups. The no version of this command deletes one or more virtual-addresses configured
in the system.
Example
OS10(conf-eth1/1/5-vrid-254)# virtual address 10.1.1.15
Supported
Releases
10.2.0E or later
vrrp delay reload
Sets the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay reload seconds
Parameters seconds — Enter the number of seconds for the VRRP reload time, from 0 to 900.
Default 0
Command Mode CONFIGURATION
692 Layer 3