Users Guide

Supported
Releases
10.4.3.0 or later
system identifier
Sets a non-default unit ID in a non-stacking configuration.
Syntax
system identifier system-id
Parameters system-id — Enter the system ID, from 1 to 9.
Default Not configured
Command Mode CONFIGURATION
Usage Information The system ID displays in the stack LED on the switch front panel.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0(R3S). Also
supported in SmartFabric mode starting in release 10.5.0.
Example
OS10(config)# system identifier 1
Supported
Releases
10.3.0E or later
terminal
Sets the number of lines to display on the terminal and enables logging.
Syntax
terminal {length lines | monitor}
Parameters
• length lines — Enter the number of lines to display on the terminal from 0 to 512; default 24.
• monitor — Enables logging on the terminal.
Default 24 terminal lines
Command Mode EXEC
Usage Information Enter zero (0) for the terminal to display without pausing.
Example
OS10# terminal monitor
Supported
Releases
10.2.0E or later
traceroute
Displays the routes that packets take to travel to an IP address.
Syntax
traceroute [vrf {management | vrf-name}] host [-46dFITnreAUDV] [-f first_ttl]
[-g gate,...] [-i device] [-m max_ttl] [-N squeries] [-p port] [-t tos] [-l
flow_label] [-w waittime] [-q nqueries] [-s src_addr] [-z sendwait] [--
fwmark=num] host [packetlen]
Parameters
• vrf management— (Optional) Traces the route to an IP address in the management VRF instance.
• vrf vrf-name — (Optional) Traces the route to an IP address in the specified VRF instance.
• host — Enter the host to trace packets from.
• -i interface — (Optional) Enter the IP address of the interface through which traceroute sends packets.
By default, the interface is selected according to the routing table.
• -m max_ttl — (Optional) Enter the maximum number of hops for the maximum time-to-live value that
traceroute probes. The default is 30.
82 CLI Basics