Users Guide

Supported Releases 10.2.0E or later
description
Congures an ACL description.
Syntax
description text
Parameters text — Enter the description text string. A maximum of 80 characters.
Default Disabled
Command Modes IPV4-ACL, IPV6-ACL, MAC-ACL
Usage Information The no version of this command deletes the ACL description.
Example
OS10(conf-ipv4-acl)# description ipacltest
Supported Releases 10.2.0E or later
ip access-group
Assigns an IP access group to an interface.
Syntax
ip access-group access-list-name {in | out}
Parameters
• access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
• in — Apply the ACL to incoming trac.
• out — Apply the ACL to outgoing trac.
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command deletes an IP ACL conguration.
Example
OS10(conf-if-eth1/1/8)# ip access-group testgroup in
Supported Releases 10.2.0E or later
ip access-list
Creates an IP access list to lter based on an IP address.
Syntax
ip access-list access-list-name
Parameters access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# ip access-list acl1
524 Access Control Lists