Users Guide

Example
OS10(config)# route-map bgp
OS10(conf-route-map)# match extcommunity extcommlist1 exact-match
Supported Releases 10.3.0E or later
match interface
Congures a lter to match routes whose next-hop is the congured interface.
Syntax
match interface interface
Parameters interface — Interface type:
• ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the next-hop
interface.
• port-channel id-number — Enter the port-channel number as the next-hop interface, from 1 to 128.
• vlan vlan-id —Enter the VLAN number as the next-hop interface, from 1 to 4093.
Default Not congured
Command Mode ROUTE-MAP
Usage Information The no version of this command deletes the match.
Example
OS10(conf-route-map)# match interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)#
Supported Releases 10.2.0E or later
match ip address
Congures a lter to match routes based on IP addresses specied in IP prex lists.
Syntax
match ip address {prefix-list prefix-list-name | access-list-name}
Parameters
• prefix-list-name — Enter the name of the congured prex list. A maximum of 140 characters.
• access-list-name — Enter the name of the congured access list.
Default Not congured
Command Mode ROUTE-MAP
Usage Information The no version of this command deletes a match.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# match ip address prefix-list test10
Supported Releases 10.3.0E or later
564 Access Control Lists