Users Guide
Figure 5. S4148U-ON unied port groups
MX9116n Fabric Switching Engine
On the MX9116n Fabric Switching Engine module:
• QSFP28-DD port groups 1 to 12 operate only in Ethernet mode. For more information, see Double-density QSFP28 interfaces.
• QSFP28 port groups 13 and 14 operate in Ethernet 1x100GE mode by default.
• Unied port groups 15 and 16 operate in Ethernet 1x100GE mode by default, and support Fibre Channel and other Ethernet modes. In
Ethernet mode, unied port groups 15 and 16 contain dierent breakout options than QSFP28-DD and QSFP28 port groups 1 to 14.
Figure 6. MX9116n Fabric Switching Engine unied port groups
To enable Ethernet interfaces in a unied port group:
1 Congure a unied port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the switch.
port-group node/slot/port-group
2 Activate the unied port group for Ethernet operation in PORT-GROUP mode. To activate a unied port group in Fibre Channel mode,
see Fibre Channel interfaces. The available options depend on the switch.
mode Eth {100g-1x | 50g-2x | 40g-1x | 25g-4x | 10g-4x}
• 100g-1x — Reset a port group to 100GE mode.
• 50g-2x — Split a port group into two 50GE interfaces.
• 40g-1x — Set a port group to 40GE mode for use with a QSFP+ 40GE transceiver.
• 25g-4x — Split a port group into four 25GE interfaces.
• 10g-4x — Split a port group into four 10GE interfaces.
3 Return to CONFIGURATION mode.
exit
4 Enter Ethernet Interface mode to congure other settings. Enter a single interface, a hyphen-separated range, or multiple interfaces
separated by commas.
interface ethernet node/slot/port[:subport]
Congure Ethernet unied port interface
OS10(config)# port-group 1/1/13
OS10(conf-pg-1/1/13)# mode Eth 25g-4x
OS10(conf-pg-1/1/13)# exit
OS10(config)# interface ethernet 1/1/41:1
OS10(conf-if-eth1/1/41:1)#
98
Interfaces