Users Guide

○ ICMPv6-RS-NS is mapped to queue 5
○ iSCSI is mapped to queue 0
The rate limit configuration in CoPP policy before upgrade is automatically remapped to queues 6, 5, and 0
respectively after upgrade.
For example, in release 10.4.1, the following policy configuration is applied on queue 5, which in 10.4.1 is mapped to
ARP_REQ, ICMPV6_RS, ICMPV6_NS, and ISCSI protocols:
policy-map type control-plane test
!
class test
set qos-group 5
police cir 300 pir 300
After upgrade to release 10.4.2, the policy configuration appears as follows:
policy-map type control-plane test
!
class test_Remapped_0
set qos-group 0
police cir 300 pir 300
!
class test_Remapped_5
set qos-group 5
police cir 300 pir 300
!
class test_Remapped_6
set qos-group 6
police cir 300 pir 300
In release 10.4.2, ARP_REQ is mapped to queue 6, ICMPV6_RS and ICMPV6_NS are mapped to queue 5, and ISCSI is
mapped to queue 0.
By default, CoPP traffic towards the CPU is classified into different queues as shown below.
Table 83. CoPP: Protocol mappings to queues - prior to release 10.4.2
Queue Protocol
0 IPv6
1
—
2 IGMP
3 VLT, NDS
4 ICMPv6, ICMPv4
5 ARP Request, ICMPV6-RS-NS, ISCSI snooping, ISCSI-COS
6 ICMPv6-RA-NA, SSH, TELNET, TACACS, NTP, FTP
7 RSTP,PVST, MSTP,LACP
8 Dot1X,LLDP, FCOE-FPORT
9 BGPv4, OSPFv6
10 DHCPv6, DHCPv4, VRRP
11 OSPF Hello, OpenFlow
Quality of service 1315