Users Guide

Default Disabled
Command Mode INTERFACE
Usage
Information
The no version of this command disables the periodic reauthentication of 8021.X supplicants.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x re-authentication
Supported
Releases
10.2.0E or later
dot1x timeout quiet-period
Sets the number of seconds that the device remains in the quiet state following a failed authentication exchange with a
supplicant.
Syntax
dot1x timeout quiet-period seconds
Parameters quiet period seconds — Enter the number of seconds for the 802.1X quiet period timeout, from 1
to 65535.
Default 60 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout quiet-period 120
Supported
Releases
10.2.0E or later
dot1x timeout re-authperiod
Sets the number of seconds between reauthentication attempts.
Syntax
dot1x timeout re-authperiod seconds
Parameters re-authperiod seconds — Enter the number of seconds for the 802.1X reauthentication timeout,
from 1 to 65535.
Default 3600 seconds
Command Mode INTERFACE
Usage
Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout re-authperiod 7200
Supported
Releases
10.2.0E or later
dot1x timeout server-timeout
Sets the number of seconds that the device waits before retransmitting a packet to the authentication server.
Syntax
dot1x timeout server-timeout seconds
Parameters server-timeout seconds — Enter the number of seconds for the 802.1X server timeout, from 1 to
65535.
440 Layer 2