Users Guide

○ add — Attach the network policy to an interface.
○ remove — Remove the network policy from an interface.
○ number — Enter a network policy index number, from 1 to 32.
Configure advertise LLDP-MED network policies
OS10(conf-if-eth1/1/5)# lldp med network-policy add 1
Change the fast start repeat count
Fast start repeat enables a network-connectivity device to advertise itself at a faster rate for a limited amount of time. The fast
start timer starts when a network-connectivity device receives the first LLDP frame from a newly detected endpoint.
The LLDP-MED fast start repeat count specifies the number of LLDP packets that are sent during the LLDP-MED fast start
period. By default, the device sends three packets per interval. The number of packets that are sent during activation ranges
from 1 to10.
Rapid availability is crucial for applications such as emergency call service location (E911).
● Configure fast start repeat count which is the number of packets that are sent during activation in CONFIGURATION mode,
from 1 to 10, default 3.
lldp-med fast-start-repeat-count number
Configure fast start repeat count
OS10(config)# lldp med fast-start-repeat-count 5
LLDP commands
clear lldp counters
Clears LLDP and LLDP-MED transmit, receive, and discard statistics from all physical interfaces.
Syntax
clear lldp counters
Parameters None
Default Not configured
Command Mode EXEC
Usage
Information
The counter default value resets to zero for all physical interfaces.
Example
OS10# clear lldp counters
Supported
Releases
10.2.0E or later
clear lldp table
Clears LLDP neighbor information for all interfaces.
Syntax
clear lldp table
Parameters None
Default Not configured
Command Mode EXEC
576 Layer 2