Setup Guide

117 Dell EMC PowerEdge MX SmartFabric Configuration and Troubleshooting Guide
B.3 PowerEdge MX Ethernet I/O Module initial deployment
All switches running OS10EE form a redundant management cluster that provides a single REST API
endpoint to OME-M to manage all switches in a chassis or across all chassis in an MCM group. Figure 108
shows the PowerEdge MX networking IOMs in the MCM group. This page is accessed by selecting Devices
> I/O Modules.
Each IOM can be configured directly from the OME-M console. Administrative tasks include:
• Viewing IOM-specific alerts
• Power cycling the IOM
• Configuring device management information
• Configuring port breakout modes
• Updating IOM firmware
OME-M console – I/O Modules page
IOMs are configured to receive their management IP address via DHCP by default. To optionally configure
static IP addresses and hostnames on the MX9116n IOMs, do the following:
1. Open the OME-M console.
2. From the navigation menu, click Devices > I/O Modules.
3. Click IOM-A1 for the first MX9116n.
4. On the IOM-A1 page, click the Settings tab and expand Network.
5. Under IPv4 settings, uncheck the Enable DHCP box and specify a valid IP Address, Subnet Mask,
and Gateway.
6. Click Apply.
7. Expand the Management section and enter a Host Name in the field provided, for example,
MX9116n-1.