Users Guide
Table Of Contents
- Dell EMC Networking Virtual Edge Platform 1405 Series Getting Started Guide
- Contents
- About this Guide
- Site Preparations
- VEP1405 Series Installation
- Specifications
- Chassis physical design
- Safety standards and compliance agency certifications
- Product recycling and disposal
- Agency compliance
- USA Federal Communications Commission statement
- Industry Canada Statement
- Radiocommunication equipment compliance for Thailand
- Brasil – Aviso da Anatel
- European Union EMC directive conformance statement
- Japan VCCI compliance for Class A equipment
- Korean certification of compliance
- Mexico certification of compliance
- Taiwanese certification of compliance
- Singapore certification of compliance
- Support
Figure 6. VEP1405 series wall mount bracket installation - cross-shaped cutout
Rack-mounted installation
As an option, the VEP1405 series can be mounted to a dual rack mount tray. Purchased separately, you can install the VEP1405
series to the dual rack mount tray using a torque screwdriver and the eight M3 screws included.
NOTE:
When driving the screws into the bracket and VEP1405 series unit, verify that 5 lb-in is the achieved torque
setting.
NOTE: If mounting the VEP1405 series to a dual rack mount tray, removal of the rubber feet from the bottom of the
VEP1405 series unit is not necessary.
Figure 7. VEP1405 series rack mount installation
Figure 8. VEP1405 series rack installation - front and back view
Site Preparations
9