Release Notes
Table Of Contents
- Virtual Edge Platform 1405 Series DIAG OS and Tools Release Notes
- Document revision history
- Software requirements
- Important information
- BIOS installation and configuration
- VEP1405 diagnostic operating system installation
- Update BIOS, CPLD, and PIC firmware using firmware updater package
- Support resources
- Contacting Dell EMC
Figure 8. POST test
LED test
Within Test mode, the LED test option allows you to select the color of the system LED lights on the front panel:
● None
● Green
● Yellow
To adjust these settings, go to the BIOS setup screen, use the arrow keys to select the Advanced tab, select POST test, and
then select the LED test option.
Figure 9. LED test screen
Restore defaults
NOTE:
By restoring the system to the original default settings, any assigned system passwords will be restored to the
original default password. See the BIOS setup section in this document for information about the original default password.
To restore the system to the original default settings:
1. From the BIOS setup screen, use the arrow keys to select the Save & Exit tab.
2. Use the arrow keys to select the Restore Defaults option and press Enter. The Load Optimized Defaults? screen displays.
16