Owners Manual

NOTE: Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
Figure 30. Removing the intrusion switch
Next steps
1. Install the intrusion switch
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
Steps
1. Align and insert the intrusion switch in the slot until it locks in the slot on the chassis.
NOTE:
Route the cable through the cable routing tab when you replace it to prevent the cable from being pinched or
crimped.
2. Connect the intrusion switch cable to the connector on the system board.
Figure 31. Installing the intrusion switch
62
Installing and removing system components