Owners Manual

Storage controller card
The NX440 contains PERC H730P internal storage controller card.
Removing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the expansion card riser.
Steps
1. Remove the screw securing the blue release latch.
2. Rotate the blue release latch to disengage it from the PERC card.
3. Push the blue release latch until the tab clicks into the slot on the system.
4. Hold the PERC card by the edges and pull it to disengage it from the PERC card slot.
5. Flip the PERC card and disconnect the cable from the PERC card.
Figure 43. Removing the PERC card
Next steps
1. Install the PERC card
Installing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the expansion card riser.
Steps
1. Connect the PERC cable to the PERC card.
2. Flip and insert the PERC card in the PERC card slot.
Installing and removing system components
71