Users Guide

Table 19. dellemc_configure_idrac_network (continued)
Parameter Required Default Choices Comments
● T_None
auto_detect No NA
● Enabled
● Disabled
Auto detect Network Interface Controller
types for iDRAC
auto_negotiation No NA
● Enabled
● Disabled
Auto negotiation of Network Interface
Controller for iDRAC
network_speed No NA
● T_10
● T_100
● T_1000
Network speed for Network Interface
Controller types for iDRAC
duplex_mode No NA
● Full
● Half
Transmission of data Network Interface
Controller types for iDRAC
nic_mtu No None NA NIC Maximum Transmission Unit
ip_address No NA NA IP Address needs to be defined
enable_dhcp No NA NA
Whether to Enable or Disable DHCP
Protocol for iDRAC
dns_from_dhcp No NA
● Enabled
● Disabled
Specifying Domain Name System from
Dynamic Host Configuration Protocol
enable_ipv4 No NA
● Enabled
● Disabled
Whether to Enable or Disable IPv4
configuration
static_dns_1 No NA NA
Specify Domain Name System
Configuration
static_dns_2 No NA NA
Specify Domain Name System
Configuration
static_gateway No None NA
Interfacing the network with another
protocol
static_net_mask No None NA
Determine whether IP address belongs to
host
Table 20. Return Values
Name Description Returned Type Sample
iDRAC network
Configures the iDRAC
network attributes
Success String
https://github.com/dell/Dell-EMC-Ansible-
Modules-for-iDRAC/blob/master/samples/
dellemc_configure_idrac_network.md
Example
-name: Configure the iDRAC network attributes
dellemc_configure_idrac_network:
idrac_ip: "xx.xx.xx.xx"
idrac_user: "xxxx"
idrac_pwd: "xxxxxxxx"
share_name: "xx.xx.xx.xx:/share"
share_pwd: "xxxxxxxx"
share_user: "xxxx"
share_mnt: "/mnt/share"
register_idrac_on_dns: "Enabled'
dns_idrac_name: "None"
auto_config: "None"
static_dns: "None"
setup_idrac_nic_vlan: "Enabled"
vlan_id: "0"
vlan_priority: "1"
enable_nic: "Enabled"
Configuring PowerEdge Servers
21