Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
To disable the ports, select a port or multiple ports, and click Disable Admin Status.
The system displays the change status and update success message on completion.
Dell Technologies recommends to:
● Enable the port status to operationally up before adding any devices to the port, if the port is disabled using the OMNI UI.
NOTE: Devices that are connected to the disabled port are not discovered.
● Ensure that the ports are UP before adding any switches, when you expand the leaf and spine fabric deployments.
● Ensure that the switch port is in UP, when onboarding a server to a leaf switch.
Configure breakout ports
Configure breakout ports on an interface of the leaf switch.
NOTE:
By default, the auto breakout feature is enabled in spine switches. OMNI UI does not provide an option to break out
ports in spine switches.
To configure the breakout ports in a leaf switch:
1. From the SmartFabric instance, select Switches .
2. From Leaf Switches category, select a leaf switch from the list.
102
OMNI support for SmartFabric instances