Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
4. Select UnTagged network, select the OMNI network, enter an optional description, select either eBGP
or Static Route for the routing protocol, enter the routing policy information, then click Finish.
5. A route is associated with the nodes that are configured in the port configuration. The system displays uplink creation
success message.
Create L3 routed interface uplink
1. Select the SmartFabric Instance > Uplink, and click Create.
2. Select L3 routed interface, enter the Uplink name, and optional description, then click Next.
3. Select the Switch group (Leaf or Spine), the rack to create the uplink on, select the interfaces, then click Next.
OMNI support for SmartFabric instances
131