Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
Delete eBGP route from switch
1. Select an eBGP route, then click Delete Route.
2. Click Delete to remove the route from the switch.
3. The system displays route deletion success message.
Configure global settings for SmartFabric
Starting from 2.0 release, OMNI allows you to configure SmartFabric switch services settings using the UI.
You can configure the following services on the SmartFabric switches using OMNI:
● NTP
● DNS
● Syslog
● SNMP
NOTE:
This feature is supported from SmartFabric OS10.5.2.2 version or later, and applicable for SFS L3 leaf and spine
personality.
Configure NTP server
To configure an NTP server:
OMNI support for SmartFabric instances
159