Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
3. Select Wired connection 1, then click Edit.
4. Verify Ethernet (ens160) is connected to the vCenter reachable
network, then change the Profile name to vCenter Server Network.
5. Change the IPv4 configuration from Automatic to Manual from the drop-down.
NOTE:
If you are using a stand-alone generic ESXi host deployment and if DHCP services are running on the
Management network subnet, use the default IPv4 vCenter server network configuration which uses automatic IP
address assignment using DHCP. During this scenario, set the IPv4 configuration to Automatic.
30 OpenManage Network Integration