Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
path to the certificate and private key in the server. The files are copied to the OMNI VM.
5. Enter y to install the SSL certificate.
6. Unregister and register the vCenter again using OMNI UI to apply the newly installed SSL certificate.
NOTE:
Refresh the browser to view the OMNI UI plug-in from the vCenter when you register or unregister OMNI
appliance with vCenter 7.0. For older versions of vCenter, log out and log in to access the plug-in from the vCenter.
View and configure docker private network settings
The internal docker system of the OMNI VM uses a private network to communicate with the docker components. By default,
the docker bridge private network IP address is set to 172.16.0.1/16. View and change the default configuration for the docker
private network using OMNI console.
View docker private network configuration
1. Log in to OMNI console.
OpenManage Network Integration
47