Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
5. The system displays a vCenter registration successful message.
When adding the vCenter instance, you can choose only to add the instance and not register. To do so, select False for
Registered option. Selecting False adds the vCenter and no register the vCenter with OMNI. You can register later without
entering the credentials again by changing the status.
You can choose not to enable the automation services for the vCenter by selecting False for Automation option. Selecting
False creates the automation service for the specific vCenter. You can start the automation service for the vCenter whenever
required, see vCenter Maintenance mode.
Edit a vCenter instance
To edit the vCenter configuration:
56
Access the OMNI stand-alone portal