Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.1
- Contents
- About this guide
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- SmartFabric management with OMNI
- OMNI feature support matrix
- View SmartFabric instance overview
- View fabric topology
- Manage switches in a fabric
- SmartFabric bulk configuration
- Configure server interface profile
- Configure and manage uplinks
- Configure networks and routing configuration
- Configure global settings for SmartFabric
- View fabric events and compliance status
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- Lifecycle management
- Troubleshooting
- Troubleshooting tools
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
The system displays NSX-T instance creation success message.
NSX-T page displays the following information:
● NSX-T Instance—Displays the list of IP address or FQDN of the NSX-T instance.
● NSX-T Name—Displays the name of the NSX-T.
● User Name—Displays the username for NSX-T.
● Maintenance Mode—Displays the Maintenance mode of the NSX-T instance.
○ Gray—Maintenance mode is Off or disabled.
○ Green—Maintenance mode is On or enabled.
● Config Status—Displays the status of the NSX-T configuration.
Enable or Disable OMNI automation for NSX-T
With 2.1 release, you can change the Maintenance mode between In Service and Under Maintenance states using the toggle
switch.
1. Click the toggle switch to change between the modes. The system prompts for confirmation to change the mode.
2. Click Ok to confirm.
OMNI automation support for NSX-T
135