Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.1
- Contents
- About this guide
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- SmartFabric management with OMNI
- OMNI feature support matrix
- View SmartFabric instance overview
- View fabric topology
- Manage switches in a fabric
- SmartFabric bulk configuration
- Configure server interface profile
- Configure and manage uplinks
- Configure networks and routing configuration
- Configure global settings for SmartFabric
- View fabric events and compliance status
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- Lifecycle management
- Troubleshooting
- Troubleshooting tools
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
4. OMNI console displays the current docker private subnet settings with an option to change
the docker private network setting. You can ignore to change the setting by entering n.
Change docker private network default settings
When there is a conflict between the default docker private network and any other network to which OMNI is connected, OMNI
cannot communicate with the devices in that network. To avoid the conflict, you can change the docker private network default
settings in OMNI.
To change the docker private network configuration:
1. From the OMNI management menu, enter 2 to go to the Interface configuration menu.
2. Enter 0 to configure docker private network.
3. OMNI console displays the current docker private subnet settings. Any change to the docker private network setting
results in reboot of OMNI. OMNI displays confirmation to change the docker private network. Enter y to proceed with the
configuration change.
4. Enter the private network IPv4 network address for docker in A.B.C.D format with subnet mask in prefix-length /xx
format and press Enter. The docker private network address must end in x.x.x.1 or x.x.x.129 and use a /25 mask.
5. OMNI reboots to implement the latest docker private network configuration.
42
OpenManage Network Integration