Deployment Guide

Configure OMNI autodiscovered SmartFabric

instance

This information describes how to configure OMNI autodiscovered SmartFabric instances. If the OMNI virtual appliance is connected to a

link-local network on SmartFabric (such as VxRail Management Network-VLAN 3939), find the SmartFabric IPv6 VIP autodiscovered by

OMNI. For complete information about discovery, see mDNS service in SmartFabric Services.

You must edit this autodiscovered SmartFabric instance for the REST_USER password to complete the configuration.

1. Go to the OMNI portal.

2. Select Auto Discovered VIP, then click Edit.

NOTE: During VxRail initial deployment, the system forces you to change the password. If you forget the

REST_USER password, contact Dell support to reset REST_USER password.

3. Enter the service instance information, then click Submit.

4. Service instance configuration success; close the message.

Topics:

• Summary

• Topology

• Switches

• Server interface

• Uplink

• Network

• Host network inventory

OMNI SmartFabric management