Deployment Guide

5. L3 routed uplink creation success; close the message.

Network

This information describes how to configure networks, and routing configuration. You can configure three types of networks including

VxLAN networks (for L2 and L3 profiles), VLAN networks (for L2 and L3 profiles), and L3 routed interfaces (for L3 profiles only).

NOTE: Networks that are created by the OMNI user interface are considered

Manual

The OMNI vCenter PortGroup VLAN automation process does not add Manual networks to auto uplinks, and does not remove them

from SmartFabric. You should add Manual networks to uplinks using the OMNI portal if needed. The OMNI VLAN automation process

uses Manual networks for ServerInterfaces. We recommend not using the OMNI portal to create a network, if you are using those

VLANs for the OMNI registered vCenter PortGroup. OMNI automation manages those VLANs/networks by itself. For complete

information, see OMNI vCenter integration.

VxLAN networks

Create VxLAN network

1. Select Networks > VxLAN Networks, then click Create.

OMNI SmartFabric management