Deployment Guide

4. Issue a curl https request from the SmartFabric vCenter appliance console to the plug-in appliance IP configured on ens160.

SmartFabric error

Check ens192 has IPv6 link-local address that is enabled and is up.

NOTE: Multiple fabric or vCenter registrations are shown in Status SmartFabric Management Service.

1. Select 2. Status OMNI Managment Service.

All services must be active. If they are not all active, restart the service by selecting 4. Restart OMNI Management Service.

Confirm that the error is resolved.

2. Confirm the password that is supplied during registration is correct. If not correct, re-register the plug-in to update the SmartFabric

password on the appliance.

Configure NTP server

NOTE:

If the NTP server is not configured, the SmartFabric vCenter appliance VM will not synchronize with the data

center.

1. Select 2. Interface Configuration Menu.

2. Select 5. Configure NTP Server, then enter the NTP Server IP/Hostname.

Troubleshooting