Administrator Guide

Switch Management Commands 2037
Output Volts................................... 53
Output Current................................. 0
Temperature.................................... 39
In the next example, the port is specified and the command displays the
details for the single port. The detected class and power is shown, followed by
the power limit configuration. Then port counters, voltage, current and
temperate are displayed.
console#show power inline gi1/0/1 detailed
Port Powered Device State Priority Status Class Power[mW]
--------- ------------------------ ----- -------- ---------- ------- -------
--
Gi1/0/13 auto Low Searching Unknown
Limit Power High Power
Port Type Limit Mode
--------- -------- -------- -----------
Gi1/0/13 None 32000 Enabled
Overload Counter............................... 0
Short Counter.................................. 0
Denied Counter................................. 0
Absent Counter................................. 0
Invalid Signature Counter...................... 0
Output Volts................................... 53
Output Current................................. 0
Temperature.................................... 38
Command History
Example updated in 6.4 release.
show power inline firmware-version
Use the show power inline firmware-version command to display the version
of the PoE controller firmware present on the switch file system.
Syntax
show power inline firmware-version